After you successfully configured the scanner, you can verify the scanner setup by opening a text editor and scanning a barcode.

Before You Begin

Make sure that you have configured the scanner as described in the applicable connection guide.


1. Open a text editor on your mobile device.

2. Scan a test barcode with the built-in scanner and verify that you can see the data in the text file.

Example (2D Data Matrix):

After scanning the above barcode, you should see the following data in the text file:

01012345678912341723091510BATCHTEST1234 21SER1ALNUMBER001

If you cannot see the data, your scanner setup is not correct. Revisit the applicable connection guide and configure the scanner.